NEW   TRI of Japan Tube Amplifiers

Hand-wired, precision, high quality transformers and components, outstanding sound. These are quality made in Japan by audio craftsmen and are built to last a lifetime. Beautifully finished in candy metallic burgundy finish with brushed solid aluminum faceplates and knobs, they are not only great to listen to, but beautiful to look at.

KT88 single ended integrated amplifier, Output: 12watts + 12watts at 8ohms, Frequency response: 15Hz-

40 kHz (+/- 1dB), Total distortion: 0.1%(1kHz), SN level: 88dB, Input sensitivity: 0.7V, Input impedance:

100Kohm, Tube Compliment: 2- KT88 2-12AX7(ECC83), Capacitors used: Toichi Oil capacitors(Japan),

Resistors used: KOA very precise resistor(Japan), Weight 11.5kg, Dimension W230mm x D400mm x H

response: 15Hz- 50 kHz (+/- 1dB), Total distortion: 0.3%(1kHz), SN level: 85dB, Input sensitivity: 0.6V,

Input impedance: 100kohm, Output: 6 and 8 ohm speaker taps, Input terminals: 3 (LINE 1 / 2 / 3), Self

bias, Power consumption: 80watts, Tube Compliment: 2- 300b 2- 6SN7, Components used:TOICHI oil

capacitors(Japan), KOA highly precise resistors(Japan), Weight 11.5kg, Dimension W220mm x D372mm x

H 190mm

Tube Pre-Amplifier, Circuit: CR type Class A amplification, Phono Circuit: NF type, MM cartridge ,

Frequency Response: -1 and -3db (10Hz-100KHz), Signal to noise ratio: 96db, Output Impedance:

7Kohm, Input Terminal: 4 line (one pair front and three pairs rear), one pair record out, Output Terminal:

three lines, Tube compliment: 6-ECC83-amplification stage, 2-5AR4 Rectifiers, Weight 8kg,

Dimension: W340 x D315 x H185 (mm)

EL34 ClassAB push-pull integrated amplifier, Output class AB: 45 Watts + 45 Watts at 8 ohms, Frequency

response: 10Hz- 100 kHz (+/- 4dB), Total distortion: 0.1%(1kHz), SN level: 90dB, Input sensitivity: 0.4V,

Input impedance: 100k ohm, Output: 6 and 8 ohm speaker taps and one headphone terminal, Input

terminals: 4 (front 1, rear 3), Output terminals: 1 (rec out 1), Tube Compliment: 4- EL34 1-

12AX7(ECC83) 2- 12AU7 (EC82), Power consumption: 120watts(no signal), max 240 watts, Weight:

15kg, Dimension: W340mm x D315mm x  H 185mm

TRI- M300SE - 20 Watt 300B Parallel SE Mono Power Amps

precise resistor, KOA(Japan), TOICHI oil capacitor(Japan), Output: 6, 8, 16 ohm speaker taps, Frequency

response: 10 Hz - 60 Hz (+1, -3db), Total Distortion: 0.3% (1KHz), Signal to noise ratio level: 89db, Input

Sensitivity: 0.8V, Tube Compliment: Each mono block, 2 - 300B 1-12AX7 (ECC83) 1-12AU7

(ECC82) Input terminal: one balanced, one unbalanced.

Dimensions: 176W x 200H x 440 D in mm, Weight: 15 Kg

KT88 push-pull mono power amplifier, Output: Class AB, 60watts + 60watts at 8 ohms, Frequency

response: 20Hz- 55 kHz (+/- 1dB), Total distortion: 0.1%(1kHz), SN level: 90dB, Input sensitivity: 0.7V,

Input impedance: 100kohm, Output: 6 , 8 , 16ohm speaker taps, Input terminals: 1 balanced, 1 unbalanced,

Power consumption: 60 watts (no signal), max 120 watts, Tube Compliment: In each mono block, 2- KT88